SMASH
Is applied to the rubber surface of ofset printing blankets to effect a temporary repair of low spots and indentations. SMASH contains a swelling agent which, when applied to the face of the blanket in the damaged areas, will cause the surface to return to its original level, enabling the printer to finish his shift or complete a job without having to lift or change blankets. SMASH will not damage the printing surface but it will not repair cuts or any damage where the surface rubber has been destroyed.
 
Advantages:
1. Economic to use, as only affected area needs  application
2. Easy brush application to blankets
3. Can finish jobs without press tops to change blanket
 
Recommendations for use:
Identify and clean the low spot on the blanket. Apply SMASH to this area with the brush applicator in the tin cap. Leave Smash on the blanket for approximately 5-10 seconds, and then wipe off with a dry cloth. if the swelling  every is insufficient, repeat the process until the swelling recovery is sufficient to resume printing. After treatment wipe off any residue with water  to avoid any damage to the prining plate.
 
Physical and chemical properties:
Appearance: Thick liquid
Odour: Strong Methyl Chloride odor
Boiling Point: 39.8°C
Flash Point (C ): No Flash
Packing size: 250 ml. Tin/6 Tins/box
Colour Clear
Solubility: Not soluble in water
Relative Dens ty: 1.322 @20*C
pH concentrate: N/A